Isolated Current Sensors - GMW Associates https://gmw.com/product-category/hall-magnetic-and-current-sensors/isolated-current-sensors/ Tue, 24 Jan 2023 19:30:52 +0000 en-US hourly 1 https://wordpress.org/?v=6.3.2 https://gmw.com/wp-content/uploads/2020/04/cropped-favicon-32x32.png Isolated Current Sensors - GMW Associates https://gmw.com/product-category/hall-magnetic-and-current-sensors/isolated-current-sensors/ 32 32 AKM Currentier CQ / CZ Isolated Current Sensors https://gmw.com/product/akm-high-accuracy-current-sensors/ Tue, 29 Jan 2019 10:42:06 +0000 https://gmw1.wpenginepowered.com/?post_type=product&p=1079 The AKM Currentier™ CQ / CZ Series Current Sensors are open-type current sensors using a Hall sensor, which outputs the analog voltage proportional to the AC/DC current. Very thin film is used as the Hall sensor, which enables the high-accuracy and high-speed current sensing. Coreless ultra-small surface mount package realizes the space-saving.

The CQ / CZ current sensors have linear sensing ranges from +/- 8.5A to +/- 129A (20A to 60A RMS), depending on the specific part. Response times as low as 0.5uS, and bandwidth up to dc to 1.5mHz. All the sensors are very low noise, <3mV.

]]> Senis CS-03 High Sensitivity Isolated Current Sensor https://gmw.com/product/cs-03-series/ Tue, 29 Jan 2019 10:47:36 +0000 https://gmw1.wpenginepowered.com/?post_type=product&p=1081 Senis CS-03 Series replaces Senis CS-02 Series Current Sensors. CS-02 should not be used for new designs.

Suggested alternatives:
Ametes CS0.25A-02 : Senis CS0.25A-03
Ametes CS2.5A-02 : Senis CS2.5A-03
Ametes CS10A-02 : Senis CS8A-03

Senis CS-03 is a PCB mount current sensor with a magnetic shied, multi-turn coil, high performance Hall IC and robust package.

]]> Senis BBM-03-LV Series – Low/Medium Bus Bar Current Sensor https://gmw.com/product/bbm-03-lv-series-low-medium-bus-bar-current-sensor/ Fri, 20 Jan 2023 21:43:53 +0000 https://gmw1.wpenginepowered.com/?post_type=product&p=28373 Bus Bar current sensor modules enable measurement of currents in the large f-bandwidth of DC to 200kHz without an impact of external magnetic fields.

The SENIS Bus Bar DC Current Sensor locates two magnetic field sensors on each side of
current bus bar. Two precision Hall ICs sense the magnetic field as a function of current on both sides. This allows to effectively cancel external magnetic fields without magnetic cores or shielding, thus avoiding non-linearities and hysteresis effects. The differential Hall voltage between the upper and the lower sensor provides a full scale output of 0±4.0V. DC current ranges that can be sensed depend on the geometry of the bus bar. The BBM-03-LV is supplied with a shielded cable connected to a RJ45 plug.

The BBM-03 Sensors replace BBM-02 and BBM-01 Series.

 

]]>